Instruction notes:
Replace the "ISCSI_USER" token with one of the values in the "username" column above.
Replace the "ISCSI_PASS" token with the corresponding value in the "password" column above.
Replace the "ISCSI_TARGET_HOST" token with the corresponding value in the "IP Address" column above.

Setup Instructions:
Download and install the Windows ISCSI initiator
Open the ISCSI Initiator configuration at Start -> All Programs -> Microsoft iSCSI Initiator
Select the "Discovery" tab.
Click the "Add" button under "Target Portals".
Type or paste the "ISCSI_TARGET_HOST" into the "IP address or DNS name" input box and leave the "Port:" setting at the default of "3260".
Click on the "Advanced" tab.
Under the "General" tab enable "CHAP logon information" by selecting the check box.
Type or paste your username ("ISCSI_USER") into the "User name:" input box.
Type or paste your password ("ISCSI_PASS") into the "Target secret:" input box.
Click the "OK" button.
Click the "Ok" button.
Select the "Targets" tab.
Select the new target from the "Targets:" selection list.
Click on the "Log on..." button to open the "Log On to Target" popup menu.
Select the "Automatically restore this connection when the system boots" check box if you would like this connection to persist between reboots.
Click on the "Advanced..." button.
Under the "General" tab enable "CHAP logon information" by selecting the check box.
Type or paste your username ("ISCSI_USER") into the "User name:" input box.
Type or paste your password ("ISCSI_PASS") into the "Target secret:" input box.
Click the "OK" button.
Click the "OK" button.
The status for the target should now be set to "Connected" under the "Targets" tab.
Click the "OK" button.

Add to Favourites
Print this Article